 |
 |
 |
 |
|
 |
 |
http://www.ultralightnews.ca/ Page 19 of 36
The Ultralight News - your one stop Ultralight News.
Exhaust gas manifold (check fitting and condition)
Exhaust system (check fixtures and condition)
Sparkplugs and sparkplug leads (check fitting and condition)
Fuel system (check for leakage and dirty filter)
4.4Starting the engine for the first time
1.Turn on the ignition system.
2.Turn on the injection system.
3.Open the throttle valves fully.
4.Turn the injection system on a second time for a total of 10 seconds of purge to allow the system to fully
evacuate air from the system.
5.Close the throttle fully.
6.Engage starter to start the engine. Should the engine not start, you may need to open the throttle valves
slowly during start up.
Note: The starting sequence should be interrupted after a maximum of 20 seconds, if the engine doesn?t start.
After a short break repeat starting sequence.
7.As soon as the engine runs on it?s own, release the starter switch/button and keep engine running with 2-
3short burst of acceleration.
8.Warm up the engine at 2000-3000 RPM under a light load
9.When the engine is warm, adjust throttle to idle
10.During and after the first operation you have to do the following test on the injection system:
Check the fuel lines and connections for leaks.
Check fuel lines for cracks and signs of rubbing.
Check electrical lines for secure connections and signs of stress.
Check throttle cable for smooth operation and security.
Check idle speed and adjust if necessary.
Replace any damaged parts in accordance to proper installation procedures to avoid damage.
4.5Normal engine starting procedure
Cold Engine
1.Turn on the ignition system.
2.Turn on the injection system.
3.Start the engine with throttle fully closed. Should the engine not start under those conditions, open the
throttle slowly while starting the engine.
Note: If engine doesn?t start, stop the starting sequence after a maximum of 20 seconds. After a short
break, repeat starting sequence.
4.If engine fails to start after repeated attempts with above procedure. Advance throttle to full open
position. This will cause the injectors to spray at 100% for 1 second. Return throttle to closed position
and repeat starting procedure. If the engine fails to start do not repeat this step as engine will become
flooded.
5.As soon as engine has started, release the starter switch/button and keep engine running with 2-3 short
accelerations.
6.Warm engine at 2000-3000 RPM under a light load.
|
|
